AMWEI Ordering Code: AMZ11-07N22RN250
Appearance and Dimension
PTC Thermistor Kinked Lead Coated Disk Drawing
PTC Thermistor Straight Lead Coated Disk Drawing
- Resin coated ceramic disc
- Coated ceramic disk outer diameter D : 8.0mm max.
- Coated ceramic disk thickness T: 5.0mm max.
- 2 Tinned lead wire space F: 5.0± 1mm
- Pin wire diameter d: 0.6mm
- Pin wire length L: 25mm min.
- Ceramic body disk H: 11mm max.
- Application: Overcurrent protection, Overload, Short circuit protection.
- Best suited to meet the requirements for power supplies motor transformer protection, eg inside transformer wire coil.
- Error-free operations are assured by rush current.
- Circuit is protected until current is turned off.
- Restores the original low resistance value automatically once the overload is removed.
- Non-contact design leads to long life and no noise.
- Durable and strong against mechanical vibration and shock.
- Resistance @25C R25 :22Ω +/- 30%
- Rated voltage (RMS) : 230 V
- Maximum operating voltage Vmax: 250 V
- Maximum withstanding voltage Vwith: 350 V
- Maximum permissible repetitive turn over current Imax: 0.5A
- Hold Current (Non-trip Current) at +25℃ : 120 mA
- Hold Current (Non-trip Current) at +60℃: 80 mA
- PTC Thermistor Trip Current, Operating Current at +25℃ It : 210 mA
- Curie temperature (Switch temperature) : 100±10 ℃
- Operating ambient temperature range (V=0): -40~+125C
- Operating ambient temperature range (V=Vmax) : 0~60C
||Room temperature, 0.5A; 250V
Number of cycles: 100
||storage at Voltage: 230V
Ambient temperature: +60C
Test duration: 1000 h
||Temperature of air: 40℃,
Relative humidity of air: 93%,
Duration: 56 days
Test according to IEC 60068-2-78
|Lead wire tensile
||Test Ua: pull strength 10N, 10 seconds,
Test Ub: bending 90°, pull strength 5N,
Test Uc: revolving 180°,
||T1 = Top,min (0 V), T2 = Top,max (0 V)
Number of cycles: 5
Test duration: 30 min
Test according to IEC 60068-2-14, test Na
||Dry heat: T = Top,max (0 V)
Test duration: 16 h
Damp heat first cycle
Cold: T = Top,min (0 V)
Test duration: 2 h
Damp heat 5 cycles
Tests performed according to
Loose bulk, or Production tape package.